Extron-electronics BUC 202 Setup Guide Manual de usuario descargar pdf

IMPORTANT:

Go to www.extron.com for the complete

user guide, installation instructions, and

specifications before connecting the

product to the power source.

BUC 202 • Setup Guide

This guide provides instructions for an experienced installer to set up and operate the Extron

BUC 202 two channel unbalanced/balanced audio converter and line driver.

Rear Panel Features and Cabling

100-240V 50/60 Hz

0.2A MAX

TRIM

OUTPUTS

BUC 202

-15

-18

-21

-3

-6

-9

-12

-15

-18

-21

-3

-6

-9

-12

INPUTS

AC power — Connect to standard AC power: 100 to 240 VAC, at 50 or 60 Hz.

Trim adjustment (channels 1 and 2) — Adjust the audio input level for the channel using

the 16-position rotary switch. This switch sets the level in 3 dB increments from -21 dB to

+21 dB. The arrow on the shaft indicates the current setting.

Input connector — This 3.5 mm 5-pole captive screw connector accepts line level

balanced or unbalanced, mono or stereo audio signals (see the illustrations below for

proper wiring).

Unbalanced Stereo Input

Balanced Stereo Input

Tip

Ring

Tip

Ring

Sleeves

Tip

Sleeve

Tip

Unbalanced Dual Mono Input

Balanced Dual Mono Input

(high impedance)

Tip

Ring

Sleeve

Tip

Sleeve

Do not tin the wires!

Tip-ring-sleeve and tip-sleeve connections:

NOTE: Unity gain (0 dB) for both channels is at the 12 o’clock

(vertical) position with the arrow on the shaft pointing to the 0

position. When the switch is set to the bottom position (indicated

by a dot) the signal is muted (see Adjusting the Trim).

TRIM

-15

-18

-21

-3

-6

-9

-12

-15

-18

-21

-3

-6

-9

-12

Sleeve ( )

Ring (R)

Tip (L)

Tip (+)

Sleeve ( )

Tip-Ring-SleeveTip-Sleeve

1 2 3 4

Indice de contenidos

Pagina 1 - BUC 202 • Setup Guide

IMPORTANT:Go to www.extron.com for the complete user guide, installation instructions, and specifications before connecting the product to the power s

Pagina 2 - Adjusting the Trim

BUC 202 • Setup Guide (Continued)ATTENTION: The length of the exposed wires in the stripping process is critical. The ideal length is 3/16 inches (5

Pagina 3 - Using the ZipClip™ 200

Find the trim adjusment setting according to the following table. OutputInputBalancedUnbalancedConsumer1Professional2Consumer1Professional2Balanced Un

Pagina 4 - Inside of Rack

BUC 202 • Setup Guide (Continued)Mounting to Rack Rails Using a ZipClip1. Fasten the ZipClip 200 mounting clip to a rack rail using two rack screws

Comentarios a estos manuales

Sin comentarios

Extron-electronics BUC 202 Setup Guide Manual de usuario

Busca en linea o descarga Manual de usuario para Accesorios de audio Extron-electronics BUC 202 Setup Guide. Extron Electronics BUC 202 Setup Guide User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios de audio Extron-electronics BUC 202 Setup Guide