Extron electronics MPA 152 Manual de usuario descargar pdf (Pagina 17)

-0!!MPLIlERs)NSTALLATION

2-5

a 5SETHETWOXSCREWSPROVIDEDTOSECURE

THEAMPLIlERTOTHEBRACKET

b)FREQUIREDSECURETHEPOWERSUPPLYUSINGTHEPLASTIC

TIESPROVIDEDWITHTHEKIT

The projector pole can be clamped to the back surface of

the clamping plate on the PMK 300, as shown in the

ﬁgure on the previous page.

Alternatively, the PMK 300 has a hole in the bottom

plate that allows the projector pole to be inserted through

the center of the plate. In this conﬁguration, slide the

PMK 300 up from the bottom of the pole before the

projector is installed.

3 !TTACHTHERUBBERPADTOTHESURFACEOFTHECLAMPINGPLATE

THATWILLBEINCONTACTWITHTHEPOLE

4 0LACETHE5BOLTAROUNDTHEPROJECTORPOLEANDINSERTTHE

TWOENDSTHROUGHTHESLOTTEDHOLESINTHECLAMPINGPLATE

ANDTHENTHROUGHTHEROUNDHOLESINTHEBACKINGBRACE

The provided U-bolt ﬁts a pole with an external diameter

of 1.5" to 2.0". For larger or smaller diameter poles,

obtain a U-bolt from a local hardware store. The slotted

holes in the clamping plate can accommodate U-bolts

that are 1.0" to 2.5" in width.

5 3ECURETHEBRACKETTOTHEPROJECTORPOLEWITHTHE5BOLTAND

THEPROVIDEDHEXNUTSANDWASHERS5SEANAPPROPRIATELY

SIZEDSOCKETWRENCHTOTIGHTENTHEHEXNUTS

Plenum placement

4HE-0!MEETS5,REQUIREMENTSFORHEATANDSMOKE

RELEASEANDCANBEINSTALLEDINTHECEILINGPLENUMSPACE

Although the ampliﬁer is plenum rated, the power

supply provided with it is not. The power supply

must not be placed in the plenum space. All cables

connected to the ampliﬁer must be plenum rated.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Sin comentarios

Extron electronics MPA 152 Manual de usuario Pagina 17