
Extron DVS 304 DVI Series Digital Video Scalers • Specications 2
Sync
Input type �������������������������������������� (RGBHV, RGBS, RGsB) pass-through, RGBHV, RGBS, RGsB, RGBcvS, bi-level or
tri-level component video
Output type ����������������������������������� RGBHV, RGBS, RGsB, and component video tri-level
Standards ��������������������������������������� NTSC 3�58, NTSC 4�43, PAL, SECAM
Optional SDI input: SMPTE 259M-C
Input level �������������������������������������� 2�75 V to 5�0 Vp-p for RGBHV or RGBS
0�6 Vp-p for component video tri-level sync
0�3 Vp-p for component video bi-level sync or RGsB
Output level ����������������������������������� TTL: 5�0 Vp-p, unterminated
Input impedance ���������������������������� 510 ohms
Output impedance ������������������������� 90 ohms
Max� input voltage ������������������������� 5 Vp-p
Max� propagation delay ������������������ 45 ns
Polarity ������������������������������������������� Positive or negative (selectable)
Audio — DVS 304 DVI A, DVS 304 DVI AD
Gain ����������������������������������������������� Unbalanced output: 0 dB; balanced output: +6 dB
Frequency response ������������������������ 20 Hz to 20 kHz, ±0�6 dB
THD + Noise ����������������������������������� 0�03% @ 1 kHz at nominal level, 0 dB gain
S/N ������������������������������������������������� >90 dB at maximum output (unweighted)
Crosstalk ���������������������������������������� <-103 dB @ 1 kHz, fully loaded; <-88 dB, wideband (20 Hz to 20 kHz), fully loaded
Stereo channel separation �������������� >80 dB @ 1 kHz
CMRR �������������������������������������������� >55 dB @ 20 Hz to 20 kHz
Audio input — DVS 304 DVI A, DVS 304 DVI AD
Number/signal type ������������������������ 4 stereo, balanced/unbalanced
Connectors ������������������������������������ (4) 3�5 mm captive screw connectors, 5 pole
Impedance ������������������������������������� >18k ohms unbalanced/balanced, DC coupled
Nominal level ��������������������������������� +4 dBu (1�23 Vrms), -10 dBV (316 mVrms)
Maximum level ������������������������������� +18 dBu, (balanced or unbalanced) at 1%THD+N
Input gain adjustment �������������������� –15 dB to +9 dB, adjustable per input
NOTE: 0 dBu = 0�775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
Audio output — DVS 304 DVI A, DVS 304 DVI AD
Number/signal type ������������������������ 1 stereo, balanced/unbalanced
Connectors ������������������������������������ (1) 3�5 mm captive screw connector, 5 pole
Impedance ������������������������������������� 50 ohms unbalanced, 100 ohms balanced
Gain error �������������������������������������� ±0�1 dB channel to channel
Maximum level (Hi-Z) ���������������������� >+21 dBu, balanced or unbalanced at 1% THD+N
Maximum level (600 ohm) �������������� >+15 dBm, balanced or unbalanced at 1% THD+N
Output volume range ��������������������� 0 to 100 (-52 dB to 0 dB) in 0�5 dB increments from steps 25 to 100,
1 dB increments from step 0 to 24
Control/remote — decoder/scaler
Serial control port ��������������������������� RS-232, 1 female 9-pin D connector
Baud rate and protocol ������������������� 9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configurations ����� 1 = input 1 select
2 = Tx
3 = Rx
4 = input 2 select
5 = GND
6 = input 3 select
7 = input 4 select
8 = n/a
9 = n/a
Ethernet control port ���������������������� 1 female RJ-45 connector
Ethernet data rate �������������������������� 10/100Base-T, half/full duplex with autodetect
Ethernet protocol ��������������������������� ARP, ICMP (ping), IP, TCP, UDP, DHCP, HTTP, SMTP, Telnet
Comentarios a estos manuales