Extron-electronics IPCP Pro Series User Guide Manual de usuario descargar pdf (Pagina 31)

IPCP Pro Series • Software-based Configuration and Control 25

Software-based

Configuration and

Control

This section of the guide is divided into the following topics:

• Configuration and Control: an Overview

• Basic Setup Steps: a Guide to this Section and Other Resources

• Downloading the Software and Getting Started

• Troubleshooting

Configuration and Control: an Overview

An IPCP must be configured before use in order to recognize and accept commands

and pass them on to the controlled devices. It can be conﬁgured and controlled via a host

computer connected to the same network as the control processor. See LAN or LAN A

(IP) connectors and LEDs starting on page16 for details about LAN port and cabling

to connect the control processor to the network.

• Configure the control processor by using the Global Configurator software in

GCProfessional or GC Plus mode. See the Extron website for full system hardware and

software requirements.

• The default web pages embedded within the control processor provide a means to view

general hardware information, network settings, and, if configured, project information.

The embedded web pages can also be used to update the IPCP firmware. You cannot

configure the control processor via the embedded web pages.

PRELIMINARY

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 46 47

Sin comentarios

Extron-electronics IPCP Pro Series User Guide Manual de usuario Pagina 31