Extron electronics CS 120P Guía de usuario descargar pdf (Pagina 12)

6. Configure the CS 120P for a U.S. or metric ceiling grid — For U.S. ceilings (2 feet

by 2 feet or 2 feet by 4 feet), leave intact the four tabs that are on one of the short ends

of the enclosure.

For metric ceilings (600 mm by 600 mm or 600 mm by 1200 mm), cut off the tabs.

Tabs (4)

Removable

Tabs

Figure 5. Tabs on the CS 120P

7. Remove the cover plate — Loosen (do not remove) the two screws on the cover

plate and remove it, as shown in figure 6.

Cover Plate

Figure 6. Removing the Cover Plate

8. Route the cables through the cover plate —

NOTES:

• The CS 120P is fully UL 2043 compliant only when it is used with a metal

conduit or with plenum rated cables.

• Installation of all conduits, conduit adapters, wiring, and electrical connections

must conform to all applicable building codes and local ordinances.

Using a flexible conduit:

a. Route wires through the conduit.

b. Insert the conduit into the cover plate opening using an appropriate conduit

adapter, and secure the conduit to the plate as shown below.

c. Pull the wires out of the conduit and through the cover plate.

CS 3T and CS 120P User Guide • Installation 7

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 36 37

Sin comentarios

Extron electronics CS 120P Guía de usuario Pagina 12