Extron-electronics DVCM 50 Quick Start Guide Manual de usuario descargar pdf (Pagina 8)

DVCM 50 Quick Start Guide, cont’d

DVCM 50 • Quick Start Guide

PRELIMINARYPRELIMINARY

Conﬁ guring the DVCM 50

The DVCM 50 can be programmed using the following methods:

• IR learning from your DVD or VCR remote control

• IR data transfer from another DVCM 50 that has been conﬁ gured previously

• Using DVD/VCR drivers with the MLC 52/DVCM 50 Windows

-based

conﬁ guration software.

Conﬁ guring using IR learning

You can conﬁ gure the DVCM 50 by using IR learning, which does not require

conﬁ guration software. By this method, you can program the functions on your

DVD and/or VCR’s remote control into the buttons on the DVCM front panel.

To program the DVCM via IR learning, follow these steps:

Step 1

Apply power to the DVCM.

Step 2

Set conﬁ guration switch #1 on the rear panel to On, as shown at

right. All other switches should be Off.

Step 3

Press the DVD or VCR button on the front panel to select the mode in which

the button will be programmed. The LED lights above the button you pressed,

indicating that the front panel buttons will be programmed in that mode.

Step 4

Press the button on the front panel that will store the IR code that you want the

DVCM to learn. The following takes place on the DVCM rear panel:

• The orange button indicator LED(s) light and remain lit to show which button

was pressed. The diagram on the next page shows which LEDs are lit when

each button is pressed.

234

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Sin comentarios

Extron-electronics DVCM 50 Quick Start Guide Manual de usuario Pagina 8