Extron-electronics ES3610_11 User Guide Manual de usuario descargar pdf (Pagina 57)

Appendix B: Understanding VN-GLIMPSE Performance ES3610/11 User Guide

I447GB issue 6 Page 57

Adjusting the Encoder Parameters

Using the VN-GLIMPSE Setup Utility (see page 32) you can set the following parameters:

• Bandwidth Limit – If you are using a large number of RGB ADPATERS or you have a

slow/busy network, you can reduce this value which sets the maximum possible flow of data

being streamed onto the network. However, remember that this could cause the refresh rate

to be reduced, especially during periods of high source activity.

• Refresh Rate (frames/sec) – If you have a source which does not require a particularly high

refresh rate, but has a reasonably active content you can set the maximum possible refresh

using this value. By keeping the Bandwidth Limit high you can keep both latency and the

average bandwidth usage to a minimum.

1 2 ... 52 53 54 55 56 57 58 59

Sin comentarios

Extron-electronics ES3610_11 User Guide Manual de usuario Pagina 57