Extron-electronics MLC 52 Series User Guide Manual de usuario descargar pdf (Pagina 55)

By default the installation creates a MediaLink folder at the following location on

your computer hard drive: C:\Program Files [or Program Files (x86)]\Extron\

MediaLink

. The following items are placed in the folder:

• MediaLnk52.exe (MLC 52/DVCM 50 Configuration Program)

• MLC_52_and_DVCM_50_Help.chm (MLC 52 configuration program help file)

Starting the Configuration Program

NOTE: It is not necessary to have an MLC 52 connected and powered up in order to

start the configuration program if you start it in emulation mode.

To run the configuration program:

1. On your desktop, click Start > Extron Electronics > MLC 52 + DVCM 50 >

MLC

52 + DVCM 50 Control Program.

2. On the Connection Window, select one of the two tabs:

• Select a Comm Port — This tab lets you establish a connection between your

computer and the MLC 52. The MLC must be connected to your computer

RS-232 port via either the rear panel 6-pole captive screw control connector or

the front panel 2.5 mm TRS configuration port.

From the Select a COM Port menu, select the PC communications port through

which your MLC is connected to the computer.

Figure 45. Select a Comm Port Tab

• Emulation Mode — This tab lets you open the software whether or not an

MLC 52 is attached to the computer.

Figure 46. Emulation Mode Tab

MLC 52 MediaLink Controllers • Serial Communication 49

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 73 74

Sin comentarios

Extron-electronics MLC 52 Series User Guide Manual de usuario Pagina 55