Extron-electronics PIP 444 User Guide Manual de usuario descargar pdf (Pagina 12)

Installation, cont’d

PIP 422 and PIP 444 Picture-in-Picture Processors • Installation2-4

Through-desk mounting

Mount the PIP through a desk or podium as follows:

1. Remove the feet from the underside of the PIP, if installed.

2. Attach the supplied mounting brackets to the processor with the machine

screws provided (figure 2-1).

3. Cut the proper sized hole in the mounting surface (figure 2-2).

Figure 2-2 — Through desk mounting a PIP

4. Hold the processor with the attached brackets against the underside of the

table or other furniture. Mark the location of the screw holes of the bracket on

the mounting surface.

5. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep in the mounting

surface at the marked screw locations.

6. Insert four #8 wood screws through the bracket and into the four pilot holes.

Tighten all four screws to secure the processor in place.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 61 62

Sin comentarios

Extron-electronics PIP 444 User Guide Manual de usuario Pagina 12