Extron-electronics PoleVault Digital Switcher Systems PVS 405D Manual de usuario Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 84
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
3. Install the Wallplates.
a. Connect the cables to the rear of the input
devices.
b. If desired, wire an IR emitter to the unit using a
two conductor cable. Wire the ground to G and
signal lead to S. IR signals are transmitted over
the STP cables.
NOTE: For podcasting or recording
applications, use a three conductor audio
cable and connect the audio return to
the connector marked G (ground wire),
R (black wire), and L (red wire). The other
end will be connected to the “Line Out”
connection on the PVS 405D switcher.
This option is available only with
PVT SW HDMI RGB D wallplates.
c. Mount the device into the mud ring, using the
supplied screws.
d. Attach the supplied Decora
®
faceplate.
e. Label the Decora plate with the supplied label,
using the appropriate input number. This makes
inputs easier to identify when configuring the
switcher.
f. Repeat steps a through e for other AV
wallplates.
Ñ
Connect the cables to the AV source
input devices at each location.
ñ
Mount the PVT in the mud ring then
õ
attach
the Decora faceplate.
VGA IN
AUDIO
IN OUT
LOCAL OUT
S G
HDMI IN
AUDIO IN
IR OUT
S
G
Decora
®
Faceplate
Wall
Mud Ring
Extron
PVT SW HDMI RGB D
STP Cable
from PoleVault
®
Switcher
Audio Input Cable
VGA IN
AUDIO
IN OUT
LOCAL OUT
AUDIO IN
HDMI IN
IR OUT
G
S
PoleVault Digital Systems • Installation — Stage 2 (Wallplates and MLC) 31
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 83 84

Comentarios a estos manuales

Sin comentarios