Extron-electronics PowerCage MTP AV Series User Guide Manual de usuario

68-1643-01 Rev. A08 10MTP Twisted Pair Transmitter and Receiver Modular BoardsPowerCage™ MTP AV Series User GuidePowerCage Products

PowerCage Front Panel Port, Control, and IndicatorsFor full details on the mounting, setup, and operation of the PowerCage 1600 enclosure refer to the

k Temp LED — This LED lights to indicate that the temperature within the PowerCage enclosure is high (approximately 167 °F [75 °C]) and equipment dam

Reference InformationThis section provides the specifications and part numbers for the PowerCage MTP T AV and Powercage MTP R AV modular boards.• Spec

Audio input — PowerCage MTP T AVNumber/signal type ... 1 stereo, unbalancedConnector ... (

Part NumbersPowerCage MTP AV Part NumbersThe PowerCage MTP AV boards must be installed in a PowerCage 1600 enclosure. PowerCage Enclosure and Boards P

Extron USA - WestHeadquarters+800.633.9876Inside USA/Canada Only+1.714.491.1500+1.714.491.1517 FAXExtron USA - East+800.633.9876Inside USA/Canada Only

This symbol is intended to alert the user of important operating and mainte-nance (servicing) instructions in the literature provided with the equipme

FCC Class A NoticeThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rule

ContentsIntroduction ... 1About this Guide ... 1About the PowerCage

Introduction• About this Guide• About the PowerCage MTP AV Transmitters and Receivers• FeaturesAbout this GuideThis guide contains information abou

Features• PowerCage MTP T AV transmits composite video or S-video along with summed mono audio signals 1,000 feet (300 meters) or more over a single

Installation and OperationThis section describes the installation and operation of the PowerCage MTP T AV and MTP R AV, including:• Installing the Bo

3. Carefully slide the board into the slot, aligning that the two tabs on the lower front end of the board with the matching ports in the enclosure.

NOTES: The length of exposed wires is critical. The ideal length is 3/16 inch (5 mm).If the stripped section of wire is longer than 3/16 inch, the ex