Extron-electronics TPS150 User Guide Manual de usuario

TPS150Twisted Pair A/V Switching and Transmission System68-958-01 Rev. C10 06

Introduction, cont’dTPS150 Switching and Transmission System • Introduction1-4TP Cable AdvantagesTwisted pair cable is much smaller, lighter, more fle

1-5TPS150 Switching and Transmission System • IntroductionAudio output volume adjustment and muting — The output has volume controladjustment via the

Introduction, cont’dTPS150 Switching and Transmission System • Introduction1-6

TPS150 Switching and Transmission System2Chapter TwoInstallationMounting the Transmitter and ReceiverCabling and Rear Panel ViewsTP Cable Termination

Installation, cont’dTPS150 Switching and Transmission System • Installation2-2InstallationMounting the Transmitter and ReceiverThe TPS150 comes with r

2-3TPS150 Switching and Transmission System • Installation3. Insert the transmitter into the rack, aligning the holes in the mounting bracketwith thos

Installation, cont’dTPS150 Switching and Transmission System • Installation2-4Cabling and Rear Panel ViewsTransmitter connectionsAll connectors are on

2-5TPS150 Switching and Transmission System • InstallationTP and audio output connections5Output UTP Link connector — Connect one end of a TP cable to

Installation, cont’dTPS150 Switching and Transmission System • Installation2-68RS-232 port — Connect a host device, such as a computer or touch panelc

2-7TPS150 Switching and Transmission System • InstallationVideo output connections12RGB/VGA video connector — Connect a VGA cable between this 15-pin

This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipmen

Installation, cont’dTPS150 Switching and Transmission System • Installation2-8TP Cable TerminationRJ-45 termination must comply with the TIA/EIA T 568

TPS150 Switching and Transmission System3Chapter ThreeOperationControls and IndicatorsOperationsOptimizing the VideoTroubleshooting

Operation, cont’dTPS150 Switching and Transmission System • Operation3-2OperationControls and IndicatorsTransmitter controls and indicatorsThe TPT150

3-3TPS150 Switching and Transmission System • Operation5Volume up and down buttons — The Volume up ( ) and Volume down ( )buttons are used to increase

Operation, cont’dTPS150 Switching and Transmission System • Operation3-4OperationsThe following paragraphs detail the power-up process and then descri

3-5TPS150 Switching and Transmission System • OperationPress the Projector Power button on the transmitter to issue the projector on or offcommand. W

Operation, cont’dTPS150 Switching and Transmission System • Operation3-6Optimizing the VideoThe TPR150 receiver features cable equalization controls f

3-7TPS150 Switching and Transmission System • OperationTroubleshootingThis section gives recommendations on what to do if you have problems operatingt

Operation, cont’dTPS150 Switching and Transmission System • Operation3-8Specific problemsThe table below shows some common operating problems and thei

TPS150 Switching and Transmission System4Chapter FourSerial CommunicationsICS100 Windows-Based Control ProgramSerial Commands

QS-1TPS150 Switching and Transmission System • Quick StartQuick Start — TPS150 Switchingand Transmission SystemInstallationStep 1Turn off power to the

Serial Communications, cont’dTPS150 Switching and Transmission System • Serial Communications4-2Serial CommunicationsThe transmitter must be programme

4-3TPS150 Switching and Transmission System • Serial CommunicationsEstablishing communications with the programThe TPT150 transmitter will not operate

Serial Communications, cont’dTPS150 Switching and Transmission System • Serial Communications4-4The transmitter’s serial port is factory-configured to

4-5TPS150 Switching and Transmission System • Serial Communications9. Click Inline Model > Query Hardware to configure the ICS100 program tocommuni

Serial Communications, cont’dTPS150 Switching and Transmission System • Serial Communications4-6Using the software to configure the serial port settin

4-7TPS150 Switching and Transmission System • Serial CommunicationsUsing the software to program the input and projector codesUse the control program

Serial Communications, cont’dTPS150 Switching and Transmission System • Serial Communications4-8c. Enter the desired code in the code window (figure 4

4-9TPS150 Switching and Transmission System • Serial Communications3. Repeat step 2 for each button or code to be programmed.4. Click in the upper ri

Serial Communications, cont’dTPS150 Switching and Transmission System • Serial Communications4-102. With the exception of input audio level, the contr

4-11TPS150 Switching and Transmission System • Serial CommunicationsSerial CommandsCommunication protocolsThe transmitter’s and receiver’s serial port

Quick Start — TPS150 Switching and Transmission SystemTPS150 Switching and Transmission System • Quick StartQS-2Step 10Connect a projector or plasma d

Serial Communications, cont’dTPS150 Switching and Transmission System • Serial Communications4-12When the system is in Pass-Through mode [CC98], comma

4-13TPS150 Switching and Transmission System • Serial CommunicationsX2 = Input number 01 – 04X3 = On/off status 0 = off, 1 = onX4 = Input volume –15 (

Serial Communications, cont’dTPS150 Switching and Transmission System • Serial Communications4-14Command/response table for programming and operating

4-15TPS150 Switching and Transmission System • Serial CommunicationsCommand/response table for programming and operating the TPT150 (Cont’d)Command AS

Serial Communications, cont’dTPS150 Switching and Transmission System • Serial Communications4-16Command/response table for programming and operating

4-17TPS150 Switching and Transmission System • Serial CommunicationsCommand/response table for programming and operating the TPT150 (Cont’d)Command AS

Serial Communications, cont’dTPS150 Switching and Transmission System • Serial Communications4-18

TPS150 Switching and Transmission SystemAAppendix AReference InformationSpecificationsPart Numbers

TPS150 Switching and Transmission System • Reference InformationA-2Reference InformationSpecificationsVideoGain...

A-3TPS150 Switching and Transmission System • Reference InformationSyncInput type ... RGBHVOutput type ...

iTPS150 Switching and Transmission System • Table of ContentsTable of ContentsChapter 1 • Introduction ...

Reference Information, cont’dTPS150 Switching and Transmission System • Reference InformationA-4Program control ... Inline Cont

A-5TPS150 Switching and Transmission System • Reference InformationPart NumbersIncluded partsThese items are included in each order for a TPS150:Inclu

Reference Information, cont’dTPS150 Switching and Transmission System • Reference InformationA-6

FCC Class A NoticeNote: This equipment has been tested and found to comply with the limits for a Class A digitaldevice, pursuant to part 15 of the FC

Extron Electronics, USA1230 South Lewis StreetAnaheim, CA 92805USA714.491.1500 Fax 714.491.1517Extron Electronics, EuropeBeeldschermweg 6C3821 AH Ame

ii TPS150 Switching and Transmission System • Table of ContentsTable of Contents, cont’dAll trademarks mentioned in this manual are the properties of

TPS150 Switching and Transmission System1Chapter OneIntroductionAbout this ManualAbout the Transmission SystemTP Cable AdvantagesFeatures

Introduction, cont’dTPS150 Switching and Transmission System • Introduction1-2IntroductionAbout this ManualThis manual contains installation, configur

1-3TPS150 Switching and Transmission System • IntroductionThe audio for the selected input is output locally. It is not sent to the receiver.The TPT1