Extron electronics MPX 866 A Guia de preparacion descargar pdf (Pagina 19)

6. After verifying that the IP address change was successful, enter

and issue the “arp –d” command at the DOS prompt. For example:

arp –d 10.13.197.7 removes 10.13.197.7 from the ARP table

arp –d* removes all static IP addresses from the ARP table.

Loading the Start-up Page

NOTES: • If your Ethernet connection to the matrix switcher

is unstable, try turning off the proxy server in your

web browser. In Microsoft Internet Explorer, click

Tools > Internet Options > Connections > LAN

Settings, uncheck the Use a proxy server...

box, and then click OK.

• For details on operating the switcher via HTML pages,

see the "HTML Operation" section in the MPX 866 A

User Guide.

1. Start the web browser program.

2. Click in the Address ﬁeld.

3. Enter the Matrix IP address in the Address ﬁeld.

NOTE: 192.168.254.254 is the factory-speciﬁed default value

for this ﬁeld.

4. Press the keyboard <Enter> key. The switcher checks whether it is

password-protected.

If the switcher is not password-protected, it checks and

downloads the HTML start-up page. The switcher is ready for

operation via HTML remote control.

If the switcher is password-protected, it downloads the Enter

Network Password page.

NOTE: A User name entry is not required.

5. Enter the appropriate administrator or user password in the

Password ﬁeld and click OK.

6. The switcher downloads the HTML start-up page, shown below.

The switcher is ready for operation via HTML remote control.

26 MPX 866 A • Remote Control 27MPX 866 A • Remote Control

1 2 ... 14 15 16 17 18 19

Sin comentarios

Extron electronics MPX 866 A Guia de preparacion Pagina 19