Extron electronics SW USB Series Instrucciones de operaciones descargar pdf (Pagina 32)

Operation, cont’d

SW USB Series • Operation

3-10

PRELIMINARY

Loading the rmware to the SW USB using the Firmware

Loader

To load a new version of rmware from your computer to your SW USB using the

Extron Firmware Loader software, your computer’s serial port must be connected

to the switcher’s RS-232 serial port. See “Rear Panel Features,” in chapter 2,

“Installation,” for information on connecting to the serial port.

. If you have not already done so, download and install the Firmware Loader

executable installer ﬁle to your computer (see “Downloading and installing

the Firmware Loader,” earlier in this chapter).

. If necessary, download the latest SW USB rmware version and install it on

your computer (see “Downloading and installing the SW USB rmware,” on

the previous page).

. Open the Firmware Loader via your desktop Start menu by making the

following selections:

Start > All Programs > Extron Electronics > Firmware Loader > Firmware

Loader

The Firmware Loader window opens to full screen size, with the Add Device

window displayed in front of it.

. On the Add Device window, select the RS-232 tab.

Add Device window RS-232 tab

Although the screen also has a TCP/IP tab, the SW USB does not have a LAN

port. Do not select the TCP/IP tab.

. From the drop-down menus, select the appropriate port conﬁguration

parameters (obtained from your system administrator). The defaults are

shown in the illustration above (9600 baud, no parity, 8 data bits, and one Stop

bit).

. If you want to upload the ﬁrmware to additional device(s),

a. Click Add Next. Your ﬁrst device is added to the Devices ﬁeld in

Firmware Loader window, and the Add Device window remains open.

. Enter the connection information for the next device.

c. Repeat steps a and b until all desired devices have been added to the

Firmware Loader window.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 45 46

Sin comentarios

Extron electronics SW USB Series Instrucciones de operaciones Pagina 32