Extron-electronics VN-MATRIX User Guide Manual de usuario descargar pdf (Pagina 93)

VN-MATRIX User Guide Section 5: Serial Transport & Control Methods

I458GB issue 6 Page 93

Serial / Telnet Commands

The following commands can be used to provide basic remote control of a VN-MATRIX system.

Commands can be issued either as part of a serial remote control configuration (see page 89) or by

using a Telnet application via the network (see page 106).

In either case, a control session must first be initiated by sending a valid username and password.

All commands must be terminated (actioned) with a ‘new line’ character (carriage return not required).

In programs such as Telnet, this is accomplished by pressing the Enter key.

Control Session Commands

user <username>

Initiates a user login. To be able to change system settings you must login using the

‘admin’ user account.

EXAMPLE: user admin

pass <password>

Specifies the password for the user account. By default this will be ‘admin’ but may have

been changed using the Web Interface (see page 81).

EXAMPLE: pass admin

exit

Terminates the current remote control session.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 137 138

Sin comentarios

Extron-electronics VN-MATRIX User Guide Manual de usuario Pagina 93