Extron-electronics MLA-VC10 Manual de usuario descargar pdf (Pagina 22)

MLA-VC10 • Installation and Setup

Installation and Setup, cont’d

2-10

MLC 206's

MLS/Power

port

Ground ( )

+12 VDC

Transmit (Tx)

Receive (Rx)

MLS / Power

Transmit (Tx)

Receive (Rx)

+12 VDC

Ground ( )

To MLA-VC10's front panel

MLC/RS-232 Power port

Figure 2-10 — Connecting an MLC 206 to MLA-VC10

Transmit (Tx)

Receive (Rx)

Computer or

Third Party Controller's

RS-232 Port

Rx Tx Gnd

Transmit (Tx)

Receive (Rx)

Ground ( ) Ground ( )

To MLA-VC10's front panel

MLC/RS-232 Power port

Figure 2-11 — Connecting a third party controller to

MLA-VC10

The length of the exposed wires in the stripping process

is critical. The ideal length is 3/16” (5 mm). If the

stripped section of wire is longer than 3/16”, the exposed

wires may touch, causing a short circuit between them.

If the stripped section of wire is shorter than 3/16”, the

wires can be easily pulled out even if tightly fastened by

the captive screws.

Do not tin the wires. Tinned wire does not hold its

shape and can become loose over time.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Sin comentarios

Extron-electronics MLA-VC10 Manual de usuario Pagina 22