
Installation and
Operation
This section describes the installation and operation of the PowerCage FOX HDMI, including:
• Mounting the Units
• Rear Panel Connections, Controls, and Indications
• Transmitter Side Panel Controls
• PowerCage Front Panel Port, Control, and Indicators
• Operation
Mounting the Units
The PowerCage FOX transmitter or receiver must be installed in an Extron PowerCage
enclosure (see “Installing a Board in the Enclosure” on page 42.)
Rear Panel Connections, Controls, and Indications
PowerCage
FOX Tx HDMI
Transmitter
PowerCage
FOX Rx HDMI
Receiver
1 2
REMOTE
RS-232
RS-232
OVER FIBER
Tx Rx
Tx
ALARM
INPUT
PowerCage
FOX Tx HDMI
Tx Rx
AUDIO
HDMI
HDCP
HDMI
AUDIO
Rx
1 2
REMOTE
RS-232
RS-232
OVER FIBER
Tx Rx
Tx
ALARM
Rx
OUTPUT
PowerCage
FOX Rx HDMI
Tx Rx
LR
AUDIO
HDMI
HDCP
ON
HDMI
AUDIO
OFF
AUDIO
7
1111
6
8
10
9
55
1
2
3
3
12 12
44
Figure 2. PowerCage FOX Tx Transmitter Connectors, Controls, and Indications
a
HDMI Input connector — Connect a single link of HMI video to this
HDMI
connector. See “HDMI connectors“ on page 10 for pin assignments and to use
the LockIt HDMI Cable Lacing Bracket to secure the connector to the transmitter.
b
Audio Input connector — Connect an unbalanced stereo or mono
AUDI
audio input to this connector.
The input audio level can be set via RS-232 control (see “Audio Adjustment
area“ in the “Remote Control” section on page 29.
PowerCage FOX HDMI • Installation and Operation 5
Comentarios a estos manuales