Extron-electronics PVT Series User Guide Manual de usuario descargar pdf (Pagina 18)

Ö RGB B output (PVT RGB models) — Using CAT 5e or 6 UTP cable, connect this RJ-45

female output port labelled “RGB A out” to one of the input ports labelled B (for

example, 2B) on the PoleVault switcher.

NOTE: Cable A carries horizontal sync information and the red, green, and

blue signals. Cable B primarily carries the audio signal, the vertical sync

information, and 5 VDC to power the PVT transmitter.

G S

RGB A

OUT

RGB B

OUT

G R L

RGB A

OUT

RGB B

OUT

G S

1B RGB

1A RGB

2B RGB

2A RGB

3B RGB

/VIDEO

4B RGB

/VIDEO

3A RGB 4A RGB

POWER

N15779

12V

5A MAX

A MAX

PVT RGB D

Input #1

RGB Input Connectors on

the Rear Panel of the

PVS Switcher

Cable from

PVT Output B

Rear Panel

PVT RGB D PLUS

Input #2

Cable from

PVT Output A

Cable from

PVT Output B

Cable from

PVT Output A

Figure 15. Connecting the PVT RGB D or PVT RGB D Plus to the PoleVault

switcher

d Audio pass-through connector (PVT RGB D Plus models) — Connect an

audio source to this 3-pole connector for audo pass through output. Connect

the ground to “G”, right speaker to “R”, and left speaker to “L”.

e EDID Minder 5-pole DIP switch — If the display refresh rate and resolution

is known, set the EDID Minder 5-pole DIP switches according to the EDID table

(see “EDID Minder” section, page 13 for details).

Alternatively, if the EDID Minder is used in Learn mode, set all the DIP switches to off.

PVT Series • Connections and Settings 12

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Comentarios a estos manuales

Sin comentarios

Extron-electronics PVT Series User Guide Manual de usuario Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Extron-electronics PVT Series User Guide