Extron-electronics RGB 203 Rxi User Guide Manual de usuario descargar pdf (Pagina 12)

Conﬁguration

This section of the user guide provides information about internal conguration of

jumpers on the circuit boards and conguration of the rear panel DIP switches.

Internal Conguration

The interface is factory conﬁgured to output RGBHV or RGBS video with sync that follows

the input and is clamped to the back porch. The interface can be conﬁgured to output

positive or negative sync or to clamp on the sync tip. These reconﬁgurations all require the

interface to be opened.

1. Remove the three screws on each side and the two screws on top of the cover (see

ﬁgure 6).

RGB 203xi

BOOST

LEVEL

CONTROL

PEAK

INPUT

WITH ADSP

CENTERING

Remove (6)

Screws

Slide cover back slightly,

then lift straight up.

Figure 6. Removing RGB 203 Rxi Cover

CAUTION: Before removing the cover, take steps to prevent electrostatic discharge,

which can damage the circuit boards of the unit.

2. Lift the cover off by sliding it straight back slightly and then lifting it straight up.

RGB 203 Rxi • Conguration 6

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Sin comentarios

Extron-electronics RGB 203 Rxi User Guide Manual de usuario Pagina 12