Extron electronics MTP 15HD A Series Guía de usuario

User GuideMTP 15HD RS SeriesTwisted PairHigh Resolution Video and Serial Link MTP Transmitters and Receivers68-2205-01 Rev. B04 13

VideoFormatPre-Peak OffPre-Peak OnMax. Distance (High Quality) Max. Distance (Variable Quality)Composite, S-video, Component800'(245 m)1000&apo

Installation and OperationThis section provides information on: • Installation and Operation Overview • Front Panel Features • Transmitter Rear Panel

Front Panel FeaturesSee figure 2 to identify the front panel features on the transmitter and receiver.MTP RL 15HD RS receiverMTP T 15HD RS transmitter

d Vertical frequency DIP switch — The first DIP switch selects the vertical frequency for the pre-programmed EDID. When switched to Off (default positi

j Delay (skew adjustment) control (SEQ model only) — This control delays the selected red, green, or blue video signal by up to 62 nanoseconds. The d

Transmitter Rear Panel FeaturesFigure 3 shows the rear of an MTP T 15HD RS transmitter.OUTPUTINPUTPOWER12V 0.5A MAXTx Rx GRS-232MONITORPRE-PEA

e Pre-Peak switch — The Pre-Peak switch alters the twisted pair signal output to correct for long cable runs (see the table on page 4 for suggested s

Receiver Rear Panel FeaturesFigure 6 shows an MTP RL 15HD RS receiver.INPUTBUFFEREDOUTPUTOUTPUTPOWER12V 0.5A MAXMTP RL 15HD RSRS-232RxTxOUTPUT

Power Supply Wiring and GroundingFigure 7 shows how to wire and ground the connector.ATTENTION: Potential damage to property.• Power supply voltage

ATTENTION: Potential damage to property.• This product is intended to be supplied by a Listed Power Unit marked "Class 2" or "LPS&quo

Safety Instructions • EnglishWARNING: This symbol, , when used on the product, is intended to alert the user of the presence of uninsulated dangerou

Twisted Pair Cable TerminationFigure 8 details the recommended termination of twisted pair cables with RJ-45 connectors in accordance with the TIA/EIA

Skew Delay CompensationCAT 5, 5e, and 6 cable can lead to registration errors between the red, green, and blue video signals. Pair skew can be measure

MTP 15HD RS Series • Installation and Operation 16EDID CongurationThe MTP 15HD RS transmitter can either record EDID from a display device, or a pre

MountingThis section outlines the various mounting options available for the MTP 15HD RS Series transmitters and receivers: • Tabletop Placement • Und

Rack Mounting ProcedureThese units can be mounted an optional rack systems listed on the website (see www.extron.com). To mount the unit on a rack she

Extron Headquarters+1.800.633.9876 (Inside USA/Canada Only)Extron USA - West Extron USA - East +1.714.491.1500 +1.919.850.1000 +1.714.491.1517 FAX +

FCC Class A NoticeThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part15 of the FCC rule

Conventions Used in this GuideNotificationsThe following notifications are used in this guide:WARNING: A warning indicates a situation that has the pot

ContentsIntroduction ...1About this Guide ... 1About the MTP Trans

IntroductionThis section gives an overview of the user guide. This section also describes the MTP 15HD RS series of transmitters and receivers. Topic

The RS-232 portion of the twisted pair link: • Can be bidirectional in a one-receiver system; that is, the receiver can receive commands from the tran

Transmission DistanceThe maximum distance is determined by the frequency and resolution of the signal that is input to the transmitter. The table on p