
Specifications are subject to change without notice.
sPeCIFICaTIONs
Video
Gain .............................................. Unity
Video input
Number/signal type ..................... 1 set of proprietary analog signals
Connectors ................................... 1 female RJ-45
Video output
Number/signal type ..................... 1 RGBHV, RGBS, component video (bi-level
and tri-level), S-video, composite video
(follows input type)
Connectors
MTP U R RSA SEQ,
MTP C7 U R RSA SEQ .................. 1 female 15-pin HD for RGB
3 BNC female for Y, R-Y, B-Y
(1) 4-pin mini DIN for S-video (Y/C)
1 BNC female for composite video
All other models .......................... 1 female 15-pin HD for RGB or Y, R-Y, B-Y
(1) 4-pin mini DIN for S-video (Y/C)
1 BNC female for composite video
Nominal level ................................ 1 Vp-p for Y of component video and
S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of
component video
0.3 Vp-p for C of S-video
Minimum/maximum levels .......... 0.8 V to 1.2 Vp-p
Impedance .................................... 75 ohms (during video output only)
Return loss .................................... <-30 dB @ 5 MHz (during video output
only)
DC offset ....................................... <±20 mV with input at 0 offset
Maximum resolution .................... 1920x1200
NOTE: Refer to the user's manual for the maximum distances recommended for
specific resolutions.
Sync
Output type .................................. RGBHV, RGBS
Standards ...................................... NTSC 3.58, NTSC 4.43, PAL, SECAM
Output level .................................. 4.0 V to 5.0 Vp-p, unterminated
Output impedance ....................... 87 ohms (24 mA)
Polarity.......................................... Positive or negative (selectable)
Audio — Mtp u R RSA SeQ, Mtp u R A, Mtp c7 u R RSA SeQ
Gain .............................................. Unbalanced output: 0 dB; balanced output:
+6 dB
Frequency response...................... 20 Hz to 20 kHz, ±1 dB
THD + Noise .................................. 0.15% @ 1 kHz, 0.3% @ 20 kHz at nominal
level
S/N ................................................ >70 dB at maximum output (unweighted)
Audio input — See Mtp SeRieS tRAnSMitteRS' Audio output SpecificAtionS
Number/signal type ..................... 1 set of proprietary analog signals
Connectors ................................... 1 female RJ-45
NOTE: 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
Audio output — Mtp u R RSA SeQ, Mtp u R A, Mtp c7 u R RSA SeQ
Number/signal type ..................... 2 mono, balanced/unbalanced
Connectors ................................... (1) 3.5 mm captive screw connector, 5 pole
Impedance .................................... 50 ohms unbalanced, 100 ohms balanced
Gain error ..................................... ±1 dB channel to channel
contRol/ReMote — RS And RSA ModelS
Serial control port input/output . . RS-232 via (1) 3.5 mm, 3 pole captive
screw connector
NOTE: The serial communications link of an MTP U R RSA SEQ, MTP U R RS
SEQ, MTP C7 U R RS SEQ, or MTP U R RS is bidirectional (default), unless the
receiver's internal jumper JMP 1 is set to unidirectional.
Set up the receiver for unidirectional communication when it is to be used with
an MTP DA to avoid any RS-232/audio detection issues.
When used with an MTPX matrix switcher, set up the receiver for unidirectional
transmitter-to-receiver communication; otherwise it should be set to
bidirectional when using the RS-232 output insert connections on the matrix.
Baud rates ..................................... Up to 38400 bps at up to 600'
(183 m) (Higher data rates and distances
are possible.
Performance varies based on baud rate and
cable length.)
Protocol ........................................ Data bits = 5 - 8
Stop bits = 1 or 2
Parity = odd, even, none
Flow control = XON, XOFF, none
NOTE: Protocol is mirrored between the transmitter and the receiver.
Serial control pin configurations
. . Captive screw connectors: 1 = TX, 2 = RX,
3 = GND
GeneRAl
Recommended cable type
MTP C7 U R RSA SEQ .................. CAT 7 (shielded)
All other models .......................... CAT 5/5e/6 (shielded or unshielded)
External power supply.................. 100 VAC to 240 VAC, 50-60 Hz, external; to
12 VDC, 2 A, regulated
Power input requirements ........... 12 VDC, 0.5 A
Temperature/humidity ................. Storage: -40 to +158 ˚F (-40 to +70 ˚C) /
10% to 90%, noncondensing
Operating: +32 to +122 ˚F (0 to +50 ˚C) /
10% to 90%, noncondensing
Cooling ......................................... Convection, vents on top and sides
Mounting
Rack mount ................................. Yes, with optional 1U, 9.5" deep rack
shelf (RSU 129, #60-190-01; RSB 129,
60-604-01); 1U, 6" deep rack shelf (RSU
126, #60-190-10; RSB 126, 60-604-10); or
VersaTools
®
1U, 3.5" deep rack shelf
(RSF 123, #60-190-20; RSB 123, 60-604-20)
Furniture mount .......................... Yes, with optional Mini Under-Desk
Mounting Kit, part #70-212-01 (MBU 123)
Pole mount ................................. Yes, with optional projector mounting kit,
part #70-217-01 (PMK 100)
Enclosure type .............................. Metal
Enclosure dimensions ................... 1.7" H x 4.3" W x 3.0" D (1U high, quarter
rack wide)
(4.3 cm H x 10.9 cm W x 7.6 cm D)
(Depth excludes connectors.)
Product weight ............................. 0.6 lbs (0.3 kg)
Shipping weight ........................... 2 lbs (1 kg)
Vibration ....................................... ISTA 1A in carton (International Safe Transit
Association)
Regulatory compliance
Safety .......................................... CE, CUL, UL
EMI/EMC .................................... CE, C-tick, FCC Class A, ICES, VCCI
MTBF ............................................. 30,000 hours
Warranty ....................................... 3 years parts and labor
NOTE: All nominal levels are at ±10%.
Model Version Description Part number
MTP U R RSA SEQ
VGA, Video, Audio & RS-232 w/Skew EQ ............ 60-869-01
MTP C7 U R RSA SEQ
VGA, Video, Audio & RS-232 w/Skew EQ ...........60-1016-01
MTP U R A
Video & Audio Universal Receiver ....................... 60-869-03
MTP U R RS
VGA, Video & RS-232 ......................................... 60-869-04
Comentarios a estos manuales