Extron-electronics IPI 200 Series User Guide Manual de usuario descargar pdf (Pagina 30)

IPI 100 and IPI 200 Series • Initial Conguration

4-2

Initia Conguration

TheIPI100SeriesunitsmustbeconnectedtoaMLC226IPMediaLinkcontroller

withavalidIPaddress.SeetheMLC 226 IP User’s Manual for information about

conguringtheMLCcontroller’sIPaddress.

TheIPI200SeriesunitshaveafactorydefaultIPaddressof192.168.254.254.This

IP address must be changed to an address that will operate on your local network.

There are three ways to change the IP address setting:

 • GlobalCongurator

 • IPI200Seriesunit’sembeddedWebpages

 • AddressResolutionProtocol(ARP)command

Before you Begin

1. ObtainavalidIPaddressforyourIPI200SeriesdevicefromyourA/V

system’snetworkadministrator.

2. Writedowntheunit’sMACaddress(a12‑digitnumber)foundonalabelon

therearpaneloftheunit(ex:00‑05‑A6‑01‑0A‑74).

3. Iftheunit’sIPaddresshasbeenchangedfromthefactorydefault

(192.168.254.254), before setting a new IP address, the default IP address must

be restored byperformingaMode4reset:

RESET

IPI 200 Series

Left Side

a. Hold down the Reset button on the left side of the unit (see ﬁgure above)

untilthePowerLEDblinkstwice(6seconds),thenrelease.

The Reset button is recessed. Activate it with an Extron Tweeker or similar tool.

b. Press and release the Reset button again within 1 second.

 ThePowerLEDblinksquicklyfourtimes,conrmingtheMode4reset,

which returns the unit to its factory default IP address.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 85 86

Sin comentarios

Extron-electronics IPI 200 Series User Guide Manual de usuario Pagina 30