Extron-electronics IPI 200 Series User Guide Manual de usuario descargar pdf (Pagina 32)

Initia Conguration, cont’d

IPI 100 and IPI 200 Series • Initial Conguration

4-4

Setting the IP address using embedded Web pages

EachIPI200Seriesintercomunitcontainsanon‑boardWebserverwithinteractive

pages that can be used to conﬁgure the device.

The intercom unit must be at its factory default IP address.

TosetanIPaddressviaembeddedWebpages:

1. Connect an Ethernet crossover cable between the device and a local PC.

2. OnthePC,locatetheTCP/IPPropertiesdialogbox.

 OnWindowsXP,theTCP/IPPropertiesdialogboxisfoundat:

Start > My Network Places>right‑clicktoProperties > Local Area

Connection > right-click to Properties > Internet Protocol (TCP/IP) >

Properties.

. Record the current IP address, subnet mask, default gateway and DHCP

settings. You will need this information later to return the PC to its original

TCP/IPsettings.

IP Address:

. . .

 SubnetMask:

. . .

4. Enter the following:

  IPaddress:192.168.254.253

  Subnetmask:255.255.0.0

  Defaultgateway:<blank>

5. Click OK.

6. OpenaWebbrowseronthelocalPC.

7. Enter192.168.254.254inthebrowser’sAddresseldandpresstheEnterkey.

 Theintercomunit’sembeddedWebpageisdisplayed.

8. Click the Configuration tab.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 85 86

Sin comentarios

Extron-electronics IPI 200 Series User Guide Manual de usuario Pagina 32