Extron-electronics IPI 200 Series User Guide Manual de usuario descargar pdf (Pagina 34)

Initia Conguration, cont’d

IPI 100 and IPI 200 Series • Initial Conguration

4-6

Setting the IP address using the ARP command

AnIPI200Seriesunit’sIPaddresscanbesetusingtheDOSAddressResolution

Protocol (ARP) command.

TheIPI200Seriesunitmustbe:

 • physicallyconnectedtothenetwork

 • atitsfactorydefaultIPaddress

To set an IP address using the ARP command:

. OpenacommandpromptwindowonalocalPC.OnWindowsXP,a

command prompt window can be found at:

Start > All Programs > Accessories > Command Prompt

. At the command prompt type:

 arp‑s<IPaddress><MACaddress>

 example:C:\>arp -s 192.168.254.254 00-05-A6-00-30-5F

TheexamplecommandassignsIPaddress192.168.254.254tothedevicethat

hasaMACaddressof00‑05‑A6‑00‑30‑5F.

3. To conﬁrm the new IP address is active, perform a ping command to the new

IP address.

 example:C:\>ping

192.168.254.254

IftheIPaddresssettingwassuccessful,thedevicereplies3ormoretimes:

Reply from <IP address>: bytes=32 time <1ms TTL=64

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 85 86

Sin comentarios

Extron-electronics IPI 200 Series User Guide Manual de usuario Pagina 34