Extron-electronics Cable Retraction System User Guide Manual de usuario descargar pdf (Pagina 11)

Cable Retraction System • Before Getting Started 5

A Cable Cubby Series Installation Guide with details of the AAP bracket requirements,

along with the horizontal mounting bracket, filler module, CC200 mounting bracket kit,

AAPbrackets, and a laptop compatibility list are available at www.extron.com.

CAUTION:

• Do not operate a retractor until it is installed.

• Keep hands away from moving parts.

Determine Under-table Clearances and Connections

For all retractable system installations be certain there is adequate under-table space

and the retractor pigtail can reach under-table devices. The following diagrams show

the under-table clearances required for installation and operation of the retractor system

mounted in a Cable Cubby, TouchLink, or TLE series enclosure.

NOTES:

• To prevent objects from impeding cable retraction, ensure at least 3 inches of

clearance from the exposed cable side of the retractor enclosure.

• Excess cabling may cause clearance issues. Use zip ties to secure under-table

cabling to prevent accidental contact or entanglement with users.

If there is limited under-table access after the Cable Cubby enclosure is mounted, the

retraction system can be installed before the enclosure is mounted

(see Alternative Solutions on page18).

For CC 200 installations, see Cable Cubby 200 on page 12.

Pigtails

To make connections to devices under the table, standard retractors have 6 feet (1.8m) and

XL retractors have 4 feet (1.2m) of pigtail from the exit of the cable retainer as shown below.

Depending on the retractor mounting and the location of the devices, you may require patch

cables to extend the reach of the pigtail.

Pigtail Starts

Here

6’ (1.8 m) Std.

4’ (1.2 m) XL

Pigtail Starts

Here

6’ (1.8 m) Std.

4’ (1.2 m) XL

Figure 4. Pigtail Length

If you need to connect to devices further than the pigtails allow, contact your Extron

representative or go to www.extron.com for a full line of patch cables.

In vertical installations, the pigtail begins 9.5 inches (24.1 cm) below the table top in

CC200/300/600/800 models for both standard and XL models, and 10.5 inches (26.7 cm)

below the table top for TLP 350CV/710CV and TLE 350/710 enclosures (see figure 5 on

page 6 and figure 6 on page 7).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Sin comentarios

Extron-electronics Cable Retraction System User Guide Manual de usuario Pagina 11