Extron electronics VoiceLift Guía de instalación descargar pdf (Pagina 10)

VoiceLift Microphone Installation • Installation — Overview

2-2

Installation — Overview, cont’d

Outline of installation steps

Stage 1 — Install the VLR 102 Receiver

Drop ceiling:

c Cut a hole in the ceiling tile. (page 2-4)

c Mount the receiver housing to the ceiling tile. (page 2-4)

c Attach a conduit to the back plate if needed. (page 2-5)

Junction box:

c Install the junction box. (page 2-6)

c Attach the receiver housing to the junction box. (page 2-6)

c Attach a conduit to the junction box if needed. (page 2-6)

Wall or other hard surface:

c Install a raceway if needed. (page 2-7)

c Mark the mounting screw locations on the surface. (page 2-7)

c If using a raceway, remove the appropriate knockout in the receiver

housing. (page 2-7)

c Mount the receiver housing to the surface. (page 2-8)

Stage 2 — Connect the VLR 102 Receiver to the PoleVault System

c Pull the cables to the receiver. (page 2-10)

c Connect the cables to the receiver. (page 2-10)

c Attach the receiver dome to the housing. (page 2-11)

c Pull cables to the PoleVault switcher. (page 2-13)

Stage 3 — Configure and Test the System

c Congure the system. (page 2-14)

c Set up the microphone. (page 2-14)

c Test the system. (page 2-14)

c Complete the installation. (page 2-15)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Sin comentarios

Extron electronics VoiceLift Guía de instalación Pagina 10