Extron-electronics FOX SW8 User Guide Manual de usuario descargar pdf (Pagina 11)

FOX SW8 • Introduction 5

b Input connectors and LEDs —

Transmitter

Receivers

Local (Loop)

Application

Switcher

LOOP IN OUTIN

Switched

Application

LINK

Connectors — For one-way video, audio, and serial

communications from the transmitter to the FOX SW8

(to be switched to the receiver) connect up to eight fiber

optic cables to the input (right-hand) LC connector on the

optical transceiver blocks (see figure 3).

Connect the far end of these fiber optic cables to

the sending connectors on the transmitters or other

compatible Extron devices.

LEDs — When lit, the link is active (light is received from

the transmitter).

NOTES:

• The right-hand LEDs for transceiver blocks 2, 4,

6, and 8 may light, but do not indicate an input

to that connector.

• For HDCP compliance when the output is to

an Extron FOXBOX or PowerCage FOX HDMI

receiver, connect a ﬁber cable between this

connector and the Tx LC connector on the

receiver.

• In an HDCP compliant system, input 8

cannot be from an active transmitter

(see ﬁgure 4 on the next page).

c Loop connectors and LEDs —

Connectors — For unswitched (input

1 loops through to output 1, input 2 to

output 2, and so on), one-way video, audio, and serial communications, looped

through from the switcher, connect fiber optic cables to the Loop

(left-hand) LC connectors on transceiver blocks 1 through 7 (see figure 3).

Connect the far ends of these fiber optic cables to the receiving connectors on the

receivers or other compatible Extron devices.

NOTE: For HDCP compliance when the input is from an Extron FOXBOX or

PowerCage FOX HDMI transmitter, connect a fiber cable between this connector

and the Rx LC connector on the transmitter (see ﬁgure 4 on the next page).

LEDs — These LEDs are always lit (light is always output to these connectors).

d Output connector and LED —

Connector — For the switched output one-way video, audio, and serial

communications, connect a fiber optic cable to the Output (left-hand) LC connector on

transceiver block 8 (see figure 3).

Connect the far end of this fiber optic cable to the receiving connector on the receiver or

other compatible Extron device.

LED — This LED is always lit (light is always output on this connector).

Figure 3. Inputs and Loop and

Switched Outputs

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Comentarios a estos manuales

Sin comentarios

Extron-electronics FOX SW8 User Guide Manual de usuario Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios para vídeo Extron-electronics FOX SW8 User Guide