Extron-electronics FOX SW8 User Guide Manual de usuario descargar pdf (Pagina 16)

FOX SW8 • Remote Control 10

Error Responses

When the unit receives a valid SIS command, it executes the command and sends a

response to the host device. If the unit is unable to execute the command because the

command is invalid or it contains invalid parameters, the unit returns an error response to

the host. The error response codes are:

E10 — Invalid command

E12 — Invalid output number

E13 — Invalid range

E22 — Busy

Timeout

Pauses of 10 seconds or longer between command ASCII characters result in a timeout.

The command operation is aborted with no other indication.

Using the Command and Response Table

The Command and Response Table for SIS Commands is on page 11. Commands in

the table are NOT case sensitive. The ASCII to HEX conversion table, below, is for use with

the command and response table.

ASCII to Hex Conversion Table

•

Space

Symbol Definitions

Symbols (variables), defined below, are used in the command and response table. The

symbols represent variables in the command and response table fields.

] = Carriage return/line feed

} = Carriage return (no line feed)

E = <Escape> key (hex 1B)

• = Space (hard) character

W = Can be used interchangeably with the E character

= Can be used interchangeably with the } character

X! = Input 00 through 08 (00 = no input)

X@ = Mute/front panel lock status 0 = off (unmuted/unlocked) 1 = on (muted/locked)

X# = Transceiver module status 0 = no module installed

1 = multimode 2 = singlemode

X$ = Firmware version v.vv

X% = Transceiver module status 0 = no light input 1 = light input

X^ = Temperature nnnF = whole degree Fahrenheit

X& = Input reclocker rate 00 = Bypass (no reclocking) 02 = 2.125 Gbps

01 = 1.25 Gbps 03 = 4.25 Gbps (default)

X* = Name Up to 24 upper- and lower-case alphanumeric characters. Hyphen characters

are valid, blank and space characters are invalid. The first character must be a

letter. The last character may not be a hyphen.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 28 29

Sin comentarios

Extron-electronics FOX SW8 User Guide Manual de usuario Pagina 16