Extron-electronics PowerCage FOX Tx_Rx DVI Plus User Guide Manual de usuario descargar pdf (Pagina 15)

Figure 5. Two Way

Conﬁguration

Receiver ﬁber optic connectors and LEDs —

WARNING: These units output continuous invisible light, which may be harmful

to the eyes; use with caution. For additional safety, plug the attached

dust caps into the optical transceivers when the ﬁber optic cable is

unplugged.

NOTES: • You can connect the transmitter to one or more receivers in one of three

ways:

• One way (transmitter-Tx-to-receiver-Rx) only — Connect ﬁber

cable

(from transmitter connector

) only.

• Two way (transmitter to receiver and return) — Connect ﬁber

cable

(from transmitter connector

) and ﬁber cable

back to

the transmitter (connector

) (see ﬁgure 5.)

• One way (transmitter to receiver) with daisy

chain (receiver to receiver) — Connect ﬁber

cable

from a ﬁber optic source and cable

the next receiver in the daisy chain (see ﬁgure 6.)

Set each receiver in the daisy chain to daisy

chain mode (via an SIS command for the

PowerCage FOX Rx receiver.)

Up to 10 properly-congured receivers can be

connected in a daisy chain to a single transmitter.

• See the transmitter ﬁber connector NOTES on page 8,

which also apply to these connectors.

From Transmitter

or Daisy-Chained

Receiver

Tx Rx

Figure 6. Daisy Chain Conﬁguration

Rx (required) — For all one-way video, audio, and serial communications from the

transmitter to the receiver, connect a ﬁber optic cable to the Rx LC connector.

Connect the free end of this ﬁber optic cable to the Tx connector on the

PowerCage FOX Tx transmitter (item

on page 9) or to any other compatible

Extron ber optic device.

Tx (optional) — Connect a ﬁber optic cable to the Tx LC connector for either of

the following functions:

Normal conﬁguration — For all one-way return serial communications from the

receiver to the Rx connector on the transmitter (see ﬁgure 5.)

Daisy chain conﬁguration — For daisy-chained video, audio, and serial

communications to the Rx connector on another receiver (see ﬁgure 6.)

NOTE: The Tx connector emits light in either case and the Rx port receives light.

Connect the free end of this ﬁber optic cable to either:

• The Rx connector on the PowerCage FOX Tx transmitter (item

on page 9) or

to any other compatible Extron ber optic device

• The Rx connector on another receiver in the daisy chain.

Tx and Rx LEDs — When lit, the link is active (light is received).

Transmitter

Receiver

8b 8a

7a 7b

Tx Rx

PowerCage FOX DVI and PowerCage FOX VGA • Installation and Operation 10

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Comentarios a estos manuales

Sin comentarios

Extron-electronics PowerCage FOX Tx_Rx DVI Plus User Guide Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Extron-electronics PowerCage FOX Tx_Rx DVI Plus User Guide