Extron-electronics PowerCage FOX Tx_Rx DVI Plus User Guide Manual de usuario descargar pdf (Pagina 28)

Command/response table for SIS commands (continued)

Command ASCII Command

(host to unit)

Response

(unit to host)

Additional description

Audio mute

Mute the audio

Amt1

]

Silence the audio output of the receiver.

Unmute the audio

Amt0

]

The receiver outputs audio.

Show audio mute statue

X!]

Audio mute status is

Auto memory

Disable auto memory

55*0#

Img0

]

Enable auto memory

55*1#

Img1

]

Show auto memory status

55#

X!]

Auto Image™

Trigger Auto Image

55*2#

Img

]

Test pattern

NOTE: You must have a video input connected and the transmitter-Tx-to-receiver-Rx ﬁber cable connected for the receiver to output a

selected test pattern. The test pattern turns off if the input signal rate changes or is disconnected or if power is removed.

Output Color Bars

Tst1

]

Set the receiver to output the Color Bars test pattern.

Output grayscale

Tst2

]

Set the receiver to output the grayscale test pattern.

Output alternating pixels

Tst3

]

Set the receiver to output the alternating pixels test

pattern.

Turn test pattern off

Tst4

]

Set the receiver to output the input video (no test

pattern is selected).

Show test pattern status

X1&]

Disable and enable return link and daisy chain

NOTE: The disable return link function is primarily used and recommended when the transmitting device is a FOX 500 DA6 and the

receiver is connect to any of outputs 2 through 6 on the DA.

Disable return link

66*0*0#

Rle*0*0

]

Disable link 2.

Enable return link to

transmitter

66*0*1#

Rle*0*1

]

Enable link 2 (default setting).

Enable daisy chain

66*0*2#

Rle*0*2

]

Enable receiver daisy chain mode.

Show return link and daisy

chain status

66*0#

X1*]

Video delay

NOTES: • The Set Video Delay command delays all analog, video, and sync video planes. This can help monitors sync correctly during an

input rate change.

• Only video is delayed. Audio is not delayed.

Set video delay

Y1!

# Dly

X2)]

Delay video by an interval of

Y1!

Example:

3*3#

Dly3

]

Delay video by an interval of 0.75 seconds

(3 x 0.25 seconds).

Show video delay

X2)]

NOTE: X! = Mute and auto memory status 0 = off 1 = on

X1& = Test pattern

0 = none 2 = grayscale

1 = Color Bars 3 = alternating pixels

X1* = Rx link and daisy chain enable 0 = disable 1 = return link enable 2 = daisy chain enable

X2) = Video delay 0 = 0 second

(0 plus six steps at 0.25 seconds per step) 1 = 0.25 second 4 = 1.0 second

2 = 0.5 second 5 = 1.25 second

3 = 0.75 second 6 = 1.5 second (default)

PowerCage FOX DVI and PowerCage FOX VGA • Remote Control 23

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Comentarios a estos manuales

Sin comentarios

Extron-electronics PowerCage FOX Tx_Rx DVI Plus User Guide Manual de usuario Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Extron-electronics PowerCage FOX Tx_Rx DVI Plus User Guide