Extron-electronics PowerCage FOX Tx_Rx DVI Plus User Guide Manual de usuario descargar pdf (Pagina 17)

Making Connections

DVI connector (PowerCage FOX DVI)

Figure 8 denes the DVI pin assignments.

Pin Signal

TMDS data 2–

TMDS data 2+

TMDS data 1–

TMDS data 1+

DDC clock

+5 V power

DDC dat

MDS clock+Ground (+5 V)

No connection TMDS clock–Hot Plug Detect

TMDS data 0–

TMDS data 0+

Spare

TMDS data 2 shield TMDS data 1 shield TMDS data 0 shield

Pin PinSignal Signal

Male Connector

Female Connector

17 24

C3 C4

C1 C2

Analog Red Video

Analog Green Video

Analog Blue Video

Analog H. Sync

Analog Ground

Figure 8. DVI Connectors

NOTE: The missing pins on the included DVI cable are not required for the single link of

DVI-D data supported by the PowerCage FOX DVI. The analog video pins are not

connected. All of these unused pins are shaded gray in the ﬁgure above.

DVI signals run at a very high frequency and are especially prone to errors caused by bad

video connections, too many adapters, or excessive cable length. To avoid the loss of an

image or jitter, follow these guidelines:

• Do not exceed 16.4 feet (5 meters) on the input or buffered loop-through of the

PowerCage FOX DVI transmitter or the output of the PowerCage FOX DVI receiver.

• Use only the cable designed for DVI signals that is supplied by Extron.

• Limit or avoid the use of adapters.

• Use only cables specically intended for DVI or HDMI

signals. Use of non-DVI or non-

HDMI cables or modied cables can result in a missing video output.

PowerCage FOX DVI and PowerCage FOX VGA • Installation and Operation 12

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Comentarios a estos manuales

Sin comentarios

Extron-electronics PowerCage FOX Tx_Rx DVI Plus User Guide Manual de usuario Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Extron-electronics PowerCage FOX Tx_Rx DVI Plus User Guide