Extron electronics MGP Pro Series Guía de usuario descargar pdf (Pagina 16)

WindoWall Pro Series • Installation 10

Reset Modes Summary

Mode Activation Result Purpose

1 Hold in the Reset button while applying

power to the WindoWall Pro.

Restores the factory-installed firmware. It

does not clear the current configuration.

Mode 1 can be

used to remove a

version of firmware

if incompatibility

issues arise.

3 Hold in the Reset button until

the Reset LED blinks once (after

approximately 3 seconds). Then, within

1 second press Reset momentarily

(for less than 1 second).

Turns events on and off. During resetting,

the Reset LED blinks two times if events

are starting or three times if events are

stopping.

Mode 3 is useful

for troubleshooting.

4 Hold in the Reset button until the

Reset LED blinks twice (once after

approximately 3 seconds and

again after 6 seconds). Then, within

1 second press Reset momentarily (for

less than 1 second).

• Enables ARP capability.

• Sets the IP address, subnet address,

and gateway address to the factory

defaults.

• Sets port mapping to the factory

default.

• Turns DHCP off.

• Turn events off.

The Reset LED blinks four times in quick

succession during the reset.

Mode 4 enables

you to set

IP address

information using

ARP and the MAC

address.

It does not replace

any user-installed

firmware.

5 Hold in the Reset button until the

Reset LED blinks three times (once

after approximately 3 seconds, again

after 6 seconds, and then again after

9 seconds). Then, within 1 second

press Reset momentarily (for less than

1 second).

Performs a complete reset to factory

defaults (with the exception of the

firmware), which includes:

• Everything mode 4 does

• Reset of almost all real time

adjustments:

• Clears all ties, presets, audio or

RS-232 mutes, and I/O grouping.

• Resets all IP options.

• Removes or clears all WindoWall

Pro files.

The reset LED blinks four times in quick

succession during the reset.

Mode 5 is useful

if you want to

start over with

configuration and

uploading and also

to replace events.

NOTE: Mode 5 reset clears most adjustments. To save these settings, use the WindoWall Console

software. Select Save Project as from the File menu before you perform this reset (see the

WindoWall Console help file for more information).

NOTES:

• The reset modes listed in the table above close all open IP and Telnet connections

and all sockets.

• Each mode is a separate function, not a continuation from mode 1 to mode 5.

• Reset mode 2 is not available on the WindoWall Pro products.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 89 90

Comentarios a estos manuales

Sin comentarios

Extron electronics MGP Pro Series Guía de usuario Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Procesadores Extron electronics MGP Pro Series