Extron electronics MGP Pro Series Guía de usuario descargar pdf (Pagina 61)

WindoWall Pro Series • HTML Configuration and Control 55

DHCP radio buttons

The DHCP On radio button directs the WindoWall Pro to ignore any entered IP addresses and

to obtain its IP address from a Dynamic Host Configuration Protocol (DHCP) server (if the

network is DHCP capable).

The DHCP Off radio button turns DHCP off. Contact the local system administrator to set

this control.

IP Address field

The IP Address field contains the IP address of the connected WindoWall Pro. This value is

encoded in the WindoWall Pro flash memory.

Valid IP addresses consist of four 1-, 2-, or 3-digit numeric subfields separated by dots

(periods). Each field can be numbered from 000 through 255. Leading zeros, up to 3 digits

total per field, are optional. Values of 256 and above are invalid.

The factory-installed default address is 192.168.254.254, but if this conflicts with other

equipment at your installation, you can change the IP address to any valid value.

NOTE: IP address changes can cause conflicts with other equipment. Only local

system administrators should change IP addresses.

Gateway IP Address field

The Gateway IP Address field identifies the address of the gateway to the mail server to be

used if the Windowall Pro and the mail server are not on the same subnet.

The gateway IP address has the same validity rules as the system IP address.

Subnet Mask field

The Subnet Mask field is used to determine whether the WindoWall Pro is on the

same subnet as the mail server when you are subnetting. For more information, see

Subnetting, a Primer on page 74.

MAC Address field

The Media Access Control (MAC) Address consists of six hexadecimal character pairs

and is used to identify the processor hardware. This address is hard-coded in the unit and

cannot be changed.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 89 90

Sin comentarios

Extron electronics MGP Pro Series Guía de usuario Pagina 61