Extron-electronics FOX DA8 User Guide Manual de usuario descargar pdf (Pagina 10)

Installation and

Operation

The topics covered in this section are:

z Rear Panel Features

z Front Panel Features

z System Operation

Rear Panel Features

FOX DA8

OPTICAL OUTPUTS

INPUT

OUTIN

OUT N/A

OUTN/A

100-240V 0.3A

50/60 Hz

RS-232

Tx Rx

41 2 33 3 3 3 3 3 3

Figure 2. FOX DA8 Connectors

WARNING: This unit outputs continuous invisible light, which may be harmful and

dangerous to the eyes; use with caution. For additional safety, plug the

attached dust caps into the optical transceivers when the ﬁber optic cable

is unplugged.

NOTES: • Singlemode and multimode devices are not interchangeable. Ensure that you

connect transmitting and receiving devices that are compatible with the

FOX DA8.

• Ensure that you use the proper ber cable for your system. Typically,

singlemode ﬁber has a yellow jacket and multimode cable has an orange

jacket.

• In this guide, the term “sending connector” refers to an LC connector on a

device that outputs a ﬁber optic signal. The term “receiving connector” refers

to an LC connector that receives an optical signal.

a AC power connector — Plug a standard IEC power cord into this connector to connect

the FOX DA8 to a 100 VAC to 240 VAC, 50 or 60 Hz power source.

Extron FOX DA8 • Installation and Operation 4

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Sin comentarios

Extron-electronics FOX DA8 User Guide Manual de usuario Pagina 10