Extron-electronics FOX DA8 User Guide Manual de usuario descargar pdf (Pagina 15)

Timeout

Pauses of 10 seconds or longer between command ASCII characters result in a timeout. The

command operation is aborted with no other indication.

Using the Command and Response Table

The Command and Response Table for SIS Commands is on page 10. Lower case letters

are acceptable in the command ﬁeld.

Symbols are used throughout the table to represent

variables in the command/response ﬁelds. Command and response examples are shown

throughout the table. The following ASCII to HEX conversion table (see ﬁgure 6) is for use

with the command and response table.

ASCII to HEX Conversion Table

•

Figure 6. ASCII to HEX Conversion Table

Symbol Deﬁnitions

The following symbols (variables) are used in the command and response table. The

symbols represent variables in the unit-initiated messages and the command and response

table ﬁelds.

] = CR/LF (carriage return/line feed)

• = space

X! = Output 1 through 8

X@ = Mute status 0 = off (unmuted)

1 = on (muted)

X# = Firmware version Vx.xx

X$ = Transceiver module status 00000000 = no light input

10000000 = light input

X% = Temperature nnnF = whole degree Fahrenheit

X^ = Transceiver module status 0 = no module installed

1 = multimode

2 = singlemode

Extron FOX DA8 • Remote Control 9

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 24 25

Sin comentarios

Extron-electronics FOX DA8 User Guide Manual de usuario Pagina 15