Extron-electronics FOX DA8 Plus User Guide Manual de usuario descargar pdf (Pagina 19)

Using the Program

NOTE: The first time you connect to the Configuration (USB) port, the Found New

Hardware Wizard appears (see figure 8, below). See “Activating a USB port

for the first time,“ below.

For other connections, proceed to “Starting the program,” on the next page.

Figure 8. Found New Hardware Wizard

Activating a USB port for the first time

The first time you connect to the Configuration (USB) port, the Found New Hardware Wizard

appears (figure 8). Activate the connected USB port for your device as follows:

NOTE: If you have not installed the latest FOX Extenders Control Program (version 1.5

or newer), click Cancel, install the program, and reboot the PC. Reconnect the

computer to the Configuration port on the DA.

1. Select the No, not this time radio button and click Next.

2. Select the Install the software automatically radio button and click Next.

Follow the on-screen instructions. The wizard assigns the driver necessary to access the

DA to the connected Configuration (USB) port (this may take a few minutes).

3. Click Finish to exit the wizard.

4. Proceed to “Starting the program” on the next page or return to the “Simple

Instruction Set Control” section.

NOTE: You may need to repeat these steps if you subsequently connect the DA to

a different USB port on the same computer.

FOX DA8 Plus • Remote Control 13

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 28 29

Sin comentarios

Extron-electronics FOX DA8 Plus User Guide Manual de usuario Pagina 19